I also have libcanberra-gtk-module installed. However appmenu-gtk2-module, and appmenu-gtk3-module are already installed on my system. Tried to install appmenu-gtk-module and canberra-gtk-module and the are not found. The fact that Board at /dev/ttyACM0 is not available is mentioned does not count because with a good ATmega328p there is no issue, the programmings goes as expected. Gtk-Message: 21: 02: 50.761: Failed to load module 'canberra-gtk-module' The program starts and behaves normally. There were more warnings and critical errors afterwards related to the modules that failed to load. : Error opening serial port '/dev/ttyACM0'.Īt .(Serial.java:127)Īt .(Serial.java:71)Īt $3.(SerialMonitor.java:93)Īt (SerialMonitor.java:93)Īt (AbstractMonitor.java:220)Īt (Editor.java:2431)Īt $3200(Editor.java:71)Īt $n(Editor.java:2477)Ĭaused by: jssc.SerialPortException: Port name - /dev/ttyACM0 Method name - openPort() Īt (SerialPort.java:167)Īt .(Serial.java:123)Įrror opening serial port '/dev/ttyACM0'. When program the sketch and you getĪvrdude: error: program enable: target doesn't answer. Gtk-Message: Failed to load module 'canberra-gtk-module' /home/././AdbRemoteScreen/local.properties at (Native Method) at. 1ĭouble check connections and try again, or use -F to override please check for usbasp firmware update.Īvrdude: error: programm enable: target doesn't answer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |